 | £450 | Steam engine possibly marine | Scratch built steam engine looks to be using a commercially available cylinder block.
The steam engine is of a good size 17" long x 24" high and to a very pleasing design.
This is an older model with parts needed to finish and many parts of the engine would benefit from a good clean!
| Possibly could be used in a marine environment or as an ornament - an ideal sideboard display!
Sadly we have no drawings or other details but enough of the engine is already completed to enable
the builder to finish what would be a fine looking engine for display or possibly for use in a small
steam launch. | VIEW MORE DETAIL |
 | £4,000 | Stuart Models / Stuart Turner 6A Compound Marine Steam Engine | Approximately 3/4 completed 6A compound engine, well machined with raw castings supplied to finish the model. Comes with a full set of plans and other hardware; eg. injector, water and steam valves, gauges etc. There is enough already done to give you a huge head start but sufficient left to make it your own model. The castings alone today would cost in excess £3500 and the model is still current so any parts required could still be sourced. Once completed the engine is rated at approximately 4HP and will power an 18 to 20ft launch / boat. | An older set of castings, approximately 3/4 completed to a very high standard by a competent engineer. We beleive there are sufficient castings to complete the model however you will need some fixings and steel stock. | VIEW MORE DETAIL |
 | £250 | Atkinson3 | A well constructed ladder chassis and front axle assembly for the Atkinson 3 inch steam waggon as serialised EIM vol 4 to 7.
Comes with an older set of plans , castings are available from Reeves 2000 , makes an impressive model : length 5 ft , height 2 ft , width 20 ins .
| another nice Winter project ahead! | VIEW MORE DETAIL |
 | £1,250 | STUART MODEL No.9 | Professionally Made To Exhibition Standard | absolutely stunning model! | VIEW MORE DETAIL |
